Prusa MK3s+

Orange 3D printer that is set up on the shelf next to the "Finished Prints" bin.

Capable of resuming after power interruption

To use:

• Remove blue SD card from side of display panel.
• Put a gcode file on it that has been sliced for this printer. I sliced with the default (0.4mm) nozzle size and it seemed to work ok.
• Put the SD card back in.
• It should appear on the top of the list of files after reinserting. If not, navigate to it with the wheel.
• Click in the wheel to select it. Your print will begin soon :)

If the estimated time does not line up with what your slicer estimated, the printer may be set to fast-forward or slow down mode. If you see a percentage in the top right corner of the screen that does not say 100%, try turning the dial until it says 100%. I assume only experts should change the speed, and I am not one.